Please title this page. (Lagowski

Don Garret & Jim Lagowski - TR-1 Construction

Note: Some of these sections are large with quite a few photos. They may take an extend time to load. Please be patient.
Fuselage	Fuselage 2	Engine / Firewall	Flaps
Ailerons	Horz Stabilizer 1	Horz Stabilizer 2	Landing Gear
Rudder/VertStab	Elevator 1	Elevator 2	MAIN
Controls	Wiring Conduit	Windows/Windshield	Cowling
Doors	Engine Baffle	Instrument Panel	Wheel Fairings
Wings	Wings 2	Wings 3	Wings 4
Moving Workshops	In The Beginning	Pre-Finish +	Fuselage Dolly

Pre-Finish + Misc.

Heater - Defrost ass'y inside firewall with home made gate valve (Valve is open) Valve is Closed (i.e. No Defrost heat.)

First Time at the Airport Goodbye Workshop.

Wing Assembly Added

Tips, ailerons & flaps installed. Stripes and # to come.

Upper fairing overall. Front of upper fairing. I didn't cut. Can bend then wing goes on & then screw fron section in place. Back portion is floxed in place.

Lower rear fairing - a real pain to fit. Needed access hole for rear spar bolt. Foam Seats. Used an electric knife to trim & 3M spray adheasive to stick pieces together.


Heater - Defrost ass'y inside firewall with home made gate valve (Valve is open)	Valve is Closed (i.e. No Defrost heat.)

First Time at the Airport Goodbye Workshop.	Wing Assembly Added

Tips, ailerons & flaps installed. Stripes and # to come.

Upper fairing overall.	Front of upper fairing. I didn't cut. Can bend then wing goes on & then screw fron section in place. Back portion is floxed in place.

Lower rear fairing - a real pain to fit. Needed access hole for rear spar bolt.	Foam Seats. Used an electric knife to trim & 3M spray adheasive to stick pieces together.