Tri-R Technologies  TR-4

BUILDER'S MANUAL

This Builder's Manual is NOT the official manual as published by TRI-R Technologies.  


AILERON ASSEMBLY


Quick Links to Aileron Assembly Sub-Sections:

AILERON ASSEMBLY
PREPARE SPAR ASSEMBLY
BOTTOM HALF ASSEMBLY
PREPARE OUTBOARD END RIB FOR COUNTER WEIGHT
PREPARE FOR THE AILERON CONTROL BRACKET
BONDING LOWER SKIN
INSTALL COUNTER BALANCE TUBE
OUTER SURFACE CLOSE OUT
ASSEMBLY OF AILERON COMPONENTS
ACTUATION BRACKET


AILERON ASSEMBLY

The procedures for the four place aileron are very similar to the flap assembly. One of the primary differences is the fact that the hinge will be on the upper surface instead of the lower surface as was the case with the flap assembly.


PREPARE SPAR ASSEMBLY


BOTTOM HALF ASSEMBLY


PREPARE OUTBOARD END RIB FOR COUNTER WEIGHT


PREPARE FOR THE AILERON CONTROL BRACKET

The thickness of the aileron should not be too great to allow free movement without interference with the wing structure. If the aileron is too thick disassemble and sand away some of the height of the ribs and spar until the thickness is correct.


BONDING LOWER SKIN


INSTALL COUNTER BALANCE TUBE


OUTER SURFACE CLOSE OUT


ASSEMBLY OF AILERON COMPONENTS

 


ACTUATION BRACKET


The aileron may be installed to the wing.